Uline H-5164 Manual De Instrucciones página 2

Locking Strap
Locking
Mechanism
Tabletop
Channel
Tabletop
Channel
Reinsert
all screws
PAGE 2 OF 12
ASSEMBLY CONTINUED
2. If the locking strap is not already attached to the
leg brace assembly, slide the locking strap over the
tube of the leg brace assembly as shown. Ensure the
locking strap is oriented with the metal ring facing
downward as shown. (See Figure 2)
Figure 2
3. Insert a leg assembly and a leg brace assembly
into the two large holes along the tabletop channel
that is still connected to the tabletop. (See Figure 3)
4. Repeat steps 2-3 for the second leg assembly and
leg brace assembly.
Figure 3
5. While one person helps hold leg assemblies in
position, place the holes in the second tabletop
channel over the tubes of the table legs and table
leg braces. (See Figure 4)
Figure 4
6. Set the table channel back in place. While one
person holds the legs, use the power drill to reinsert
the five screws removed in step 1 into the holes of
the tabletop channel to secure it in place.
(See Figure 5)
Figure 5
NOTE: Ensure you orient the leg brace in the
direction illustrated with locking mechanism
still visible.
NOTE: Do not overtighten screws. Do not use a
hand screwdriver in step 5.
0621 IH-5164