Ink Pack Installation And Replacement; Ink Pack Installation/Replacement Procedure - SII IP-7900-20 Guía De Configuración Rápida

Ink pack installation and replacement

Ink pack installation/replacement procedure

1
Push the knob of the ink box cover to open the
ink box.
Ink box cover
2
Confirm the color of the ink pack to be replaced,
and pull the ink tray out of the printer.
Ink tray
3
Take the empty ink pack out of the ink tray.
If ink is not installed, go to step 4.
Push the two claws at the lower part of the plate of the
ink pack, and pull up the plate 1. Then remove the ink
pack from the hook of the ink tray 2.
Plate
Push two claws
Ink pack
42
All manuals and user guides at all-guides.com
Knob
Ink pack
1
Ink tray
2
Hook
Ink tray
4
Take a new ink pack out of the box and set it in
the ink tray.
Hook the two holes at the end of the ink pack 1 on the
ink tray's two protrusion. Then insert the plate into the
ink tray until a click is heard 2.
Plate
New ink pack
2
5
Insert the ink tray into the slot of the printer.
Note
- Insert the ink tray as far as it will go.
- The location of ink tray is determined by color. Be sure to insert
each ink tray into the specified slot.
Ink tray
6
Close the ink box cover.
Ink box cover
7
Confirm that the ink pack replacement was
completed.
- When the replacement is successfully completed, the
printer returns to the online or offline state.
- If the replacement is not completed, an error message
appears. Retry the replacement procedure beginning
with step 1.
- While ink is remaining in the subcartridge even during
replacement of ink, print operation is performed.
1
Protrusion
Ink tray