Operating Instructions; Product Description; Product Usage - Kunft KC6455 Manual De Instrucciones

sor, condenser) to prevent the risk of a fire,
follow the installation instructions.
• The appliance must not be located close to
radiators or cookers.
• Make sure that the mains plug is accessi-
ble after the appliance is installed.
Service
• Any electrical work required for servicing
the appliance should be carried out by a
qualified electrician or competent person.
• This product must be serviced by an au-
thorized Service Center, and only genuine
spare parts must be used.
• If the appliance is Frost Free.
• If the appliance contains freezer compart-
ment.
16
refrigerator freezer

2. oPEratING INStructIoNS

2.1. Product Description

1. controller.
2. Storage shelf.
3. Crisper box Cover
4. crisper box
5. Upper freezer drawer
6. Middle freezer drawer
7. Lower freezer drawer
8. adjustable feet
9. upper door shelf
10. lower door shelf
Note: Due to continued changes to our products, your refrigerator
may be slightly different from this instruction manual, but its functions
and using methods remain the same.
Note: To get more space in the freezer, you can remove drawers
(except the bottom drawer in freezer!). To get the best use out of this
product, please place all shelves, drawers in their original positions
as shown in the illustration above.

2.2. Product usage

Installing your new appliance
Before using the appliance for the first time, you should be informed
of the following tips.
Ventilation of appliance
In order to improve efficiency of the cooling system and save
energy, it is necessary to maintain good ventilation around the
appliance for the dissipation of heat. For this reason, sufficient clear
space should be available around the refrigerator.
Suggestion: It is advisable for
there to be at least 50-70mm of
space between the back of the
appliance and the wall, at least
100mm from its top, at least
100mm between its side and the
wall and a clear space in front to
allow the doors to open 135°. as
shown in following diagrams.
EN
KC6455
17