Cleaning And Maintenance; Troubleshooting - Concept ZA 7010 Manual Del Usuario

EN
OPERATING INSTRUCTIONS
The unit is designed to cut hair and beards..
CUTTING
1. Sit the person in front of you on a chair, so that the person's head is at the level of your chest.
2. Cover the person's neck and shoulders to protect against falling hair.
3. Brush the hair.
4. Switch on the appliance.
5. Cut the hair, applying slow repeated movements. Always cut small sections of hair. We recommend
starting with a higher blade guard, then using the lower ones.
6. The length of the cut can be adjusted slightly using the cut height adjustment lever (Fig. 5).
7. For easier cutting of longer and curly hair you may use a comb against the blades. Remove the cut hair to
prevent clogging of the mechanism.
8. To cut the hair around the ears and on the nape of the neck, remove the blade guard.
9. Before you cut the ear line, comb the hair over the ears. To straighten the line on the nape of the neck,
turn the mechanism vertically to the skin, and create a clean line, using slow movements (Figs. 6-8).
10. When putting down the unit during use, always switch it off.
11. Switch the unit off after use.
12. When using the unit in a bathroom, make sure you switch it off immediately after use, and disconnect
it from the wall outlet, as the proximity of water or any contact of the unit with water is very dangerous,
even when the unit is switched off!
Switch the unit off when changing the blade guards!
CUTTING OVER A COMB OR THE FINGERS
This technique requires certain skill; use it when you want a cut longer than 12 mm.
1. Use the unit without the blade guard.
2. Comb a small lock of hair upwards, hold it using a comb or the fingers.
3. Cut the hair that overhangs the fingers or the comb. Comb frequently to remove cut hair.
ZA 7010
46
EN
EN

CLEANING AND MAINTENANCE

WARNING!
Before cleaning the unit, always disconnect the power cord from the wall outlet!
Clean the blades with the supplied brush after each use.
We recommend oiling the blades after every other use. Apply several drops of oil to the teeth, and switch on
the unit to work the oil between the blades.
Don't use hair oil, petroleum or oil containing solvents to lubricate the blades. These can slow the movement
of blades when they dry.
The surface of the unit may only be cleaned using a wet cloth. Don't use any detergents or hard objects as
they may damage the unit's surface!
Never clean the unit under running water, do not rinse it, and do not submerge it in water!
The protective cover should be put on the blades after cleaning.

TROUBLESHOOTING

Problem
Motor does not run.
The blades do not cut
properly.
ACCUMULATOR DISPOSAL
The appliance contains an Ni-MH accumulator. This accumulator type contains substances that may damage
the environment when decomposing. Prior to the appliance disposal or the accumulator replacement,
remove the original accumulator and take it to a designated collection yard.
WARNING!
Never throw the accumulator into a fire!
36
35
ZA7010 ZA7010
Cause
Plug inserted into the
mains outlet incorrectly or Check the plug connection.
insufficiently.
Check for voltage, e.g. by connecting another
The mains outlet is not live.
appliance.
Refer the unit to an authorized service center for
The supply cable is damaged.
testing and repair.
Disconnect the cable from the socket. Check
The blades are not set or oiled the setting of blades and oil them. If the quality
well, or they are blunt. of the cut does not improve, the blades are blunt
and you need to replace them.
EN
Solution
ZA 7010
47