Zibro D 116 Instrucciones De Uso página 48

All manuals and user guides at all-guides.com
If desired, it is possible to connect a drainage hose to the device for permanent water
drainage. Follow these steps:
1 Unscrew the cap on the back.
2 Remove the rubber stop from the drainage spout.
3
Connect the drainage hose and ensure that the end of the hose is lower than the
spout, otherwise the water will not drain and flooding may occur.
4 Place the end of the drainage hose in a water outlet.
When you no longer wish to use the permanent water drainage, disconnect the drainage
hose from the device. Push the rubber stop back into the drainage spout and replace the
cap. Ensure that the water container is positioned correctly.
CLEANING
WARNING!
Switch off the unit and remove the plug from the mains before cleaning the
appliance or filter, or before replacing the filters.
Clean the housing with a soft, damp cloth. Never use aggressive chemicals, petrol,
detergents or other cleansing solutions. For maintenance of the filters, refer to Chapter
"Air Filter".
NOTE!
Never use this dehumidifier without the screen filter.
STORAGE
If the machine will not be used for a long period of time, take the following steps:
1 Remove the plug from the socket and empty the container. Allow the container and
the dehumidifier to dry completely.
2 Clean the air filter.
3 Store the device in a dust-free location, preferably covered with a sheet of plastic.
4
48