BGS technic 3514 Manual De Instrucciones página 4

RECOMMENDED AIR SUPPLY
No.
1 Air Tool
2 Air Hose
3 Quick Coupler
4 Oiler
5 Pressure Regulator
OPERATION
Ensure the air supply is disconnected before filling the grease chamber.
1. Remove the front end cap from the gun.
2. Drop the cartridge, containing the caulking medium into the tube.
3. Thread the end cap over the cartridge nozzle and screw back on to the gun firmly.
4. Ensure the end of the nozzle is cut off, preferably at an angle - experience will determine the ideal
angle, and amount of nozzle to cut off, for the job in hand.
5. Connect the air supply, turn ON and approach the work. Press the trigger so that caulking medium
is ejected. To stop, release the trigger. Be aware that medium will continue to be ejected for a
short period until pressure drops. You should make allowances for this.
MAINTENANCE
Before use, drain water from air tank, airline and compressor daily.
IMPORTANT
Be aware that factors other than the tool may effect its operation and efficiency, such as reduced
compressor output, excessive drain on the airline, moisture or restrictions in the line, or the use of
connectors of improper size or poor condition which will reduce air supply. Grit or gum deposits in the
tool may also reduce efficiency. Keep the tool clean at all times.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Description
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
No. Description
6 Dewatering / Filter Unit
7 & 11 Dewatering Valve
8 Shut-Off Valve
9 Dryer / Filter Unit
10 Compressor
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed