Cleaning And Maintenance Instructions - FALMEC Sintesi 90 Manual De Instrucciones

Unconfigured in- induction module
duction module (all is not configured
.
induction module
answer to UI, but
any element is rela-
ted to the effected
cooking zone.)
No communication No power supply
between UI and of induction
.
induction module module.
Bad cabling or
defect
Main power distur- 1. Failure in main
bance power frequency
.
detection
2. Overvoltage
Non assignable
failure
.
Fan failure Fan or control
electronic is defect
.
Defect ive tempe- Sensor signal out
rature probe on of valid range; sen-
.
inductor sor or electronic is
defect
Hardware defect of Defect hardware
induction module device detected
.
by the self-check
of the module
Configuration failure 2 cooking zones
are delicated to
.
the same element
of the UI
Fixed sensor value Not enough tem-
(test function for T perature change
.
probe on inductor) (10 K) within 5 min
after switch on
the hob
No Overvoltage on 400 V connection
functiona- the switch mode
lity and no power supply (no
displaying functionality)
Note:
Not each failure can be delected automatically by the system, e.g. in case of defect of the
User interface power supply.
All manuals and user guides at all-guides.com

CLEANING AND MAINTENANCE INSTRUCTIONS

Delete the hob configu-
ration and activate the
manual configuration.
Start the UI service
menu to configure the
induction module if the
listed points are not
Before cleaning the cooker, make sure that it is at room temperature.
successful replace the
module. Always clean the cooker after each use with a specific cleanser for pyroceram.
Check power and LIN
Do not use products containing:
connections. If con-
- corrosive agents (soda, acids, ammoniac).
nection is OK, replace
- abrasive agents (dusts or paste).
the module
Do not use pointed or abrasive objects.
Check main power
After cleaning, dry the appliance with a soft cloth.
voltage and frequency,
if ok replace the module
If the appliance is built-in over an oven or an electric kitchen fitted with pyrolytic system
do not operate it while the pyrolytic procedure is under way, as the overheating protec-
Replace module or User
tion of the cooker can be released (see relevant chapter).
interface
Replace the module
DISPOSAL AFTER END OF USEFUL LIFE
Replace the module
Replace the module
re-use, or a specific treatment, to remove and safely dispose of any substances that may be
harmful to the environment and remove the raw materials that can be recycled. Proper dis-
posal of these products contributes to saving valuable resources and avoid potential nega-
Delete the actual confi-
tive effects on personal health and the environment, which may be caused by inappropriate
guration
disposal of waste.
manual configuration
You are kindly asked to contact your local authorities for further information regarding the
with service menu
designated waste collection points nearest to you. Penalties for improper disposal of such
waste can be applied in compliance with national regulations.
System must cool down
INFORMATION ON DISPOSAL IN EUROPEAN UNION COUNTRIES
The EU WEEE Directive was implemented differently in each country, accordingly, if you wish
to dispose of this appliance we suggest contacting your local authorities or dealer to find
out what the correct method of disposal is.
Disconnect and correct
the power line con-
nection INFORMATION ON DISPOSAL IN NON-EUROPEAN UNION COUNTRIES
The crossed-out trash or refuse bin symbol is only valid in the European Union: if you wish
to dispose of this appliance in other countries, we suggest contacting your local authorities
or dealer to find out what the correct method of disposal is.
The Manufacturer reserves the right to make changes to the equipment at any time and
without prior notice. Printing, translation and reproduction, even partial, of this manual are
bound by the Manufacturer's authorisation.
Technical information, graphic representations and specifications in this manual are for in-
formation purposes and cannot be divulged.
This manual is written in Italian. The Manufacturer is not responsible for any transcription
or translation errors.
19
ATTENTION!
For cleaning, never use a steam equipment.
The crossed-out wheeled bin symbol on the appliance means that the product
is WEEE, i.e. "Waste electrical and electronic equipment", accordingly it must not
be disposed of with unsorted waste (i.e. with "mixed household waste"), but it
must be disposed of separately so that it can undergo specific operations for its
WARNING!