Ortotecsa G.18951 Serie Manual De Usuario página 37

How to start
1. Determine the location of the whirlpool and then, in the desired location, pressing the
brakes wheels (1).
2. Fix the tube of turbine (2) in the guide tube (3), tightening the knob (4) to ensure the desired
height.
3. Connect the Nozzle (5) into the intake (6)
4. Turn the pressure control valve (7) fully clockwise, then fully to the left to lubricate the
plunger assembly.
5. Connect to the mains pin (plug grounding) (8).
6. Move switch (9) to On position to run the product. For stopping the product, move switch (9)
to Off position.
Filling procedure
1. Fill the bath using the fill hose. The water level must be a maximum of 10 cm below the edge
of the bath and a minimum of 15 cm above the turbine.
2. Turn the pressure control valve (7) fully clockwise. This provides maximum pressure and
agitation. Turn the switch (9). Adjust the pressure of the pressure control valve (7) to achieve
the desired level of pressure and agitation.
3. To be drained, turn the drain valve (10) counterclockwise. Drain tube Ø 32mm (note, this
valve (10) is charged on the side of the bath according to the model of the bathroom. The
drain valve can be found in the lower part of the tank depending of the model)
4. If clearing is carried out in a sink, turn the pressure control valve (7), down the turbine to the
bottom of the tub, place the nozzle (5) in the sink and turn on the switch (9 ). To stop the
drain switch-off (9). To clean the waste water using the drain valve or sponge / towel.
5. To replace the thermometer (11), loosen the screws located on the back side by rotating in
the opposite direction to clockwise to release it. Enter the new (first probe) and secure by
tightening the screw again.
1. Brake wheels
2. Tube of
turbine
3. Guide tube
4. Knob
5. Nozzle
6. Intake
7. Pressure
control valve
8. Plug
9. Switch
10. Drain Valve
(Ball valve 1 ")
11. Thermometer
(double scale)
37