Installing The Rechargeable Battery Pack - Prebena 9A-MGS-55 Instrucciones De Servicio

Preparing the electrical tool
Insert battery pack (7) into the receptacle on the battery charger
until you hear an audible click.
Connect the plug of the battery charger to a suitable outlet.
Charging starts when the power plug of the battery charger is
inserted into an outlet. The "intelligent" battery charger senses the
charging state of the battery and switches to trickle charge when
battery has been charged.
Batteries will also be discharged when the tool is not in use.
For this reason
Disconnect the battery chargers plug from the electrical outlet
when charging has been completed.
Remove the rechargeable battery pack (7) to the front.
The battery pack has been fully charged.

Installing the rechargeable battery pack

Proceed as follows to install the rechargeable battery pack:
Activate safety lock (5).
Insert rechargeable battery pack (7) into the bottom of handle (6)
until it engages with an audible click.
The battery has been properly installed.
20
WARNING
Damaged power cables may cause severe or
deadly injury from electrocution.
Check the power cable and the battery
charger for damages before you connect it
to the outlet.
Only connect the battery charger to a
proper power outlet.
, you should charge batteries at regul. intervals.