Robust RB-BD 401 Manual De Instrucciones página 15

Anleitung_RB_BD_401_SPK7__ 17.06.14 07:49 Seite 15
this instructions manual. Have defective switches
replaced by an authorized service center. Do not
use tool if switch does not turn it on and off.
20. Warning
– The use of any other accessory or attachment
other than recommended it this operating
instruction or the Einhell catalog may present a
risk of personal injury.
21. Have your tool repared by an expert
– This electric appliance is in accordance with the
relevant safety rules repairing of electric
appliances may be carried out only by experts
otherwise it may cause considerable danger for
the user.
22. Connect the dust extraction device
– Wherever there are facilities for fitting a dust
extraction system, make sure it is connected and
used.
Special safety instructions
The pillar drill was designed in such a way so as to
all but eliminate potential hazards when the machine
is properly used. However, there are a few safety
precautions to observe in order to ensure that all
residual hazards are ruled out.
Ensure proper voltage
The voltage must comply with the specifications on
the rating plate.
Use a socket-outlet with earthing contact
The device may only be operated from an outlet with
the properly installed earthing contact.
Extension cable
The cord cross section of an extension cable must
measure at least 1.5 mm
a cable reel prior to use. Check the cable for defects.
Protection against electrical shock
Keep the device away from moisture. The device
must neither be damp nor be operated in a humid
environment. Prior to every use, check the device
and the mains cable with plug for damage. Avoid
bodily contact with earthed parts e.g. pipes, hot
elements, etc.
Protection against fire and explosion
There are spark producing components inside the
device. Do not use the device in the vicinity of
combustible liquids or gases. Otherwise there is a
risk of fire or explosion.
Handle the device with care
Do not use the cable to pull the plug out of the
socket. Protect the cable from heat, oil and sharp
2 . Always completely unwind
edges. Keep your tools sharp and clean so that you
can work efficiently and safely. Follow the
maintenance regulations and the instructions for
changing tools.
Wear suitable work clothes and personal
protection equipment
Loose clothing is not suitable, as it can be caught by
moving parts, causing you to become entangled.
Wear a hair net if you have long hair. As a general
rule, jewelry should not be worn when working with
machine tools. Ensure that you wear safety goggles.
Not doing so could result in eye injury.
Keep your work area neat and tidy
Disorder in the work area can easily lead to
accidents. Do not leave any tools, objects, or cable in
the direct vicinity of the work area, as this poses a
tripping hazard! Ensure that there is sufficient
lighting.
Watch out for other persons
Watch out for other persons (especially children)
when using the device, and keep them away from
your work area. Do not let anyone touch the device
or the power cable.
Store the tools in a safe location
Store unused devices in a dry, locked location that is
out of the reach of children.
Avoid overloading the device
Operate the device only within the specified output
range. Do not use any low-powered machines for
heavy duty work. Do not use tools to perform work
for which they were not intended.
Maintain a steady foothold
Ensure that you maintain a steady foothold while
working. Avoid abnormal body positions and always
keep your balance.
Pull out the mains plug
Pull out the mains plug when not using the tool, prior
to maintenance, and when changing the drill bit.
Pull out the power plug.
Ensure that the mains connection is protected by at
least a 10 A-rated fuse.
Avoid unintentional start-up
Ensure that switch is turned off when plugging the
plug into the socket.
Keep an eye on your work
Always keep an eye on your machine and the object
GB
15