Product Safety Information; Installation And Lubrication - Ingersoll Rand QA1L Serie Especifcaciones Del Producto

Product Safety Information

Intended Use:
These tools are designed to install or remove threaded fasteners.
For additional information refer to Safety Information Manual Form 04585006.
Manuals can be downloaded from ingersollrandproducts.com
Product Speci cations
Model(s)
QA1L18
QA1L12
QA1L08
QA1L05
QA1L02
QA1L05( )( )XL( )
QA1L02( )( )XL( )
† K = 3dB measurement uncertainty
pA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a speci c tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that speci c application.

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air lter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-o , to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16585861 and table on page 2. Maintenance frequency is shown in a
circular arrow and de ned as h=hours, d=days, and m=months of actual use. Items identi ed as:
1. Air lter
2. Regulator
3. Lubricator
4. Emergency shut-o valve
5. Hose diameter
80167406_ed3
Sound Level dB(A)
Free Speed
rpm † Pressure (L
1,750
1,270
850
500
250
500
250
WARNING
6. Thread size
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - through tting
(ISO15744)
)
p
76.5
78.3
76.9
77.3
77.3
78.6
78.8
EN
Vibration Level
(ISO28927)
m/s
<2.5
<2.5
<2.5
<2.5
<2.5
<2.5
<2.5
EN-1