Powering The Qlabs Electrometer On And Off; Power Connection; Powering The Qlabs ® Electrometer On - Micropoint qLabs ElectroMeter Manual Del Usuario

7. Powering the qLabs
ON and OFF

7.1 Power Connection

The qLabs ElectroMeter comes with a power supply which must be
®
plugged into the qLabs
qLabs ElectroMeter can use 4 standard AA batteries (See Section 12.2).
®
The messages on the four-cell grid displayed at the bottom
of the screen provide hints for the functions of the buttons.
7.2 Powering the qLabs
LANGUAGE
ENGLISH
ITALIANO
FRANçAIS
SKIP
OK
OFF
SET MEM
VER
When the qLabs
®
choices to power on the monitor:
1. Press and hold the "Power" button for 2 seconds to turn on the
qLabs ElectroMeter, or
®
2. Insert a fresh test strip if you are ready to perform a test. The
qLabs ElectroMeter will then prompt you to confirm the strip code.
®
Turning the qLabs
• Perform a test, or
• check the version of the software and the manufacturer information
by pressing the "VER" button, or
ElectroMeter power supply jack. Alternatively, the
®
ElectroMeter On
®
When the qLabs
powered on, it beeps and enters the
"LANGUAGE" screen.
Use "á" or "â" to select desired language
and then press "OK" to enter the next
screen; or press "SKIP" to skip the language
selection and enter the next screen directly.
If a language is selected when the meter is
initially powered on or it is manually selected
in the "LANGUAGE" screen, the meter beeps
when powered on and prompts the user to
insert a test strip automatically.
ElectroMeter is in the standby mode, you have two
ElectroMeter ON in CHOICE 1, allows the user to:
®
ElectroMeter
®
ElectroMeter is initially
®
9
EN