Kit Contents: K1, K2
New
Ref.
Description
K1
A
Burner and Orifice Assembly
K2
K2
Label
NI
B/B1
Burner Box Cover / Screw
NI
C
Burner Screw
NI
D
Gas Tube
NI
E
Spark Electrode
NI
Not Included: Reference Only
Tools Needed:
■ 1/4 inch Nut Driver
■ #2 Phillips Screwdriver
■ 1/2 inch Open End Wrench
■ 5\8 inch open End Wrench
■ Refrigerator Service Manual
This procedure is to be performed by
WARNING
!
authorized service personnel only.
ATTENTION
Improper installation, adjustment,
alteration, service or maintenance can
cause injury or property damage.
Remove Part
Be sure the appliance has been isolated
WARNING
!
from the gas and electrical supply before
ATTENTION
starting! Refer to the service manual for
details.
1. Power OFF the refrigerator.
2. Close the gas valve of the refrigerator.
3. Unscrew
; remove
.
B1
B
P.O. Box 1285
Ann Arbor, MI 48106
www.norcold.com
2118 - Burner and Orifice Assembly
A
K1
K2
Fig. 1
Questions 1-800-543-1219
B
C
D
4. Unscrew
; set aside; discard washer (if present).
C
5. Disconnect
from
.
D
A
6. Remove
.
A
Replace Part
1. Using new part, reverse Steps 6 through 1 to replace and reinstall.
Adjust as needed to make sure the gap
WARNING
!
between
ATTENTION
inch.
2. Remove backing and apply
K2
mation below - be sure it gets applied!
WARNING!
!
orifi ce adapter fi tting [2]. This can damage the press-fi t seal
and cause a propane gas leak. A propane gas leak can ignite
and cause an explosion that can result in dangerous personal
injury, death, or much property damage. Test the propane gas
connections for leaks.
Test for Gas Leaks
Do not wet or spray leak test solution on
WARNING
!
or near electrical connections or electrical
ATTENTION
components. All leak test solutions
conduct electricity and may create an
electrical shock hazard, shorts, and / or
damage circuits.
Do not use any leak test solution that
contains ammonia or chlorine. Ammonia
and chlorine corrode brass and copper
components.
638144
Service Kit
B1
E
A
K1
Fig. 2
and
is between 1/8 - 3/16
K1
E
to
. The label contains the critical infor-
B
Do not remove the orifi ce [1] from the
Part No. 640408A (12.17.2019)