Philips Expanium EXP 4118 Manual Del Usuario página 3

8
9
0
!
@
#
$
1 2
%
QUICK START MISE EN SERVICE RAPIDE
1 2
OPEN
AA
LR6
UM3
1.
3
CD
6 7
PLAY VOLUME
!!!
GENERAL INFORMATION
1
All manuals and user guides at all-guides.com
Supported formats
This set supports:
– Disc format: ISO 9660, Joliet, Multisession, UDF, Enhanced Music CD,
7
– Music file format: MP3
–Total number of music files and albums: around 350
6
Note: The number of music files that can be played depends on the
length of the file names. With short file names more files will be
5
supported.
Visit the
4
http://www.expanium.philips.com
All trademarks used are owned by their respective owners.
3
POWER SUPPLY
Battery (not supplied)
Inserting battery
• Open the battery compartment and
insert 1 alkaline battery of type AA (LR6, UM3).
• Remove battery if it is empty or if the set will not
be used for a long time.
Indication of empty battery
• Replace the battery or connect the mains adapter as
^
soon as
Batteries contain chemical substances, so they
should be disposed of properly.
POWER SUPPLY/HEADPHONES
IMPORTANT!
• Hearing safety : Do not play your headphones at a high volume. Hearing
experts advise that continuous use at high volume can permanently damage
your hearing.
• Traffic safety : Do not use headphones while driving a vehicle. It may create
a hazard and it is illegal in many countries. Even if your headphones are an
open-air type designed to let you hear outside sounds, do not turn up the
volume so high that you cannot hear what is going on around you.
4 5
HOLD OFF
BASIC FUNCTIONS
Playing a disc
With this set you can play
–all pre-recorded audio CDs
–all finalized audio CDR(W)s
–MP3-CDs (CD-ROMs with MP3 )
1 Push the OPEN 2 slider to open the CD lid.
2 Insert a disc, printed side up, by pressing gently on
the disc´s centre so that it fits onto the hub. Close
the lid by pressing it down.
3 Press 2; to start playback.
. yCd rEAd is displayed. Playback starts.
Audio disc: The current track number and the
elapsed playing time are displayed.
MP3-CD: MP3 is shown. The current album number,
track number and the elapsed playing time are dis-
played.
4 Press 9 to stop playback.
yAudio disc: The total number of tracks and the total playing time of the
yMP3-CD: The total number of albums and tracks are displayed.
Note : If the total number of album is more than 9, the display will show "− − ";
2
if the total number of tracks is more than 99, the display will show "− − − − ".
Mixed Mode CD
MP3 bit rate (data rate): 32–320 kbps and variable bit rate
(with a typical file name length of 20 characters)
X homepage
E PANIUM
A
blinks and battis displayed.
disc are displayed.
POWER SUPPLY/HEADPHONES
Average battery lifetime of 1 alkaline battery ,type AA
Playback of
ESP off (power-saving mode)
ESP on
Notes:
–Power-saving mode doubles your playtime.
–20 seconds after pressing 9, the display switches o
the set switches off automatically.
POWER SUPPLY
Mains adapter
Only use the AY 3170 mains adapter (4.5 V/300 mA
direct current, positive pole to the center pin). Any
other product may damage the set.
1 Make sure the local voltage corresponds to the
adapter´s voltage. If your mains adapter is equipped
with a voltage selector, set this selector to the local
AA
LR6
mains voltage if necessary.
UM3
2 Connect the mains adapter to 4.5V DC on the set and
Note: Always disconnect the adapter if you are
HEADPHONES
Headphones (SBC HE205)
• Connect the supplied headphones to LINE OUT/p.
Note: LINE OUT/p can also be used for
connecting this set to your HiFi system.To adjust the
sound and volume, use the controls on the connected
audio equipment and on the CD player.
BASIC FUNCTIONS
5 To remove the disc, hold it by its edge and press
the hub gently while lifting the disc.
Note: After pressing 2; it may take some time
until the first MP3 track is played.
Playing Enhanced Music CDs and Mixed Mode
CDs
On Enhanced Music CDs and Mixed Mode CDs there
well as computer data (e. g. text files, pictures, MP3 fi
1 Insert the disc and press 2; to start playback.
yC d rEAd is displayed. Playback starts. All au
played.
2 If there are MP3 and AAC files on the disc, MP3
blinks. Keep MODE pressed for 2 seconds to
select MP3 playback.
yCd rEAd is displayed. Playback starts
with the first track of the first album. All MP3
will be played.
3 To return to audio CD playback, keep MODE
pressed for 2 seconds.
Note:To protect your headphones and your Hi-Fi
system from damage, you will hear no sound
when a computer (data) file is played. Press § to
skip to the next track.
Pause
1 Press 2; to interrupt playback.
yThe time where playback was interrupted will
blink.
2 To resume playback press 2; again.
Audio disc
6 hours
6 hours