Listening To Fm Radio - Oglo MS-O-400-D Manual Del Usuario

Repeat as often as necessary (20 tracks maximum). Then press
•
order you have defined. Use the
Press the button twice to cancel programming.
•

listening to FM radio

Connect the antenna cable provided to the back of the micro hi-fi system, and fully unfold it.
1.
Turn on the micro hi-fi system and select the FM source by repeatedly pressing the
2.
the micro hi-fi system or the remote control.
Performing a full scan of the FM band
When the unit is turned on, press and hold the SCAN button on the remote control or the
1.
on the micro hi-fi system for 3 seconds to fully scan the FM band. The first thirty stations found are
stored.
To interrupt the search, press the SCAN button again.
2.
Automatically searching for a radio station
Hold down the
1.
Scanning of the FM band stops when a radio station is found.
2.
You can then briefly press the
3.
as described in the next section.
Manually searching for a radio station
Briefly press the
1.
frequency.
Each time the
2.
MHz.
If reception is poor, adjust the FM antenna or change the frequency.
3.
Automatically storing radio stations
When the micro hi-fi system is turned on, select the FM station of your choice.
1.
Press and hold the PROG button. Memory number 01 flashes on the display. Use the
2.
button to select the desired memory number. Press
FM station. MEMORISED
Repeat as often as necessary.
3.
and
or button for 2 seconds to perform an automatic scan.
or
or button on the remote control until you obtain an optimal reception
or button is pressed, the frequency decreases/increases by 0.05
appears on the display.
to start playback. Do this in the
buttons to browse through your programming.
button on the remote control to refine your search,
to confirm the programming of the
button on
button
BASS
or
37