Automatic Power Saving Function; Display Brightness - Teac NT-503 Manual Del Usuario

Settings (continued)
Line output level
*LINE OUT LEVEL
> FIX
Use to select audio level output from the analog audio output con-
nectors (LINE OUT).
FIX 0dB
A maximum of 2 Vrms is output. Select this if you want to adjust
the volume using an amplifier.
o No sound will be output if headphones are connected.
FIX +6dB
A maximum of 4 Vrms is output. Select this if you want to adjust
the volume using an amplifier.
o No sound will be output if headphones are connected.
o If the sound distorts, set this to FIX 0dB.
VARIABLE
This will enable adjustment of the analog output level using the
VOLUME knob. Select this if you want to adjust the volume using
this unit.
o No sound will be output if headphones are connected.
OFF
No sound is ever output.

Display brightness

*DIMMER
> DIMMER 3
DIMMER 3
Ordinary brightness
DIMMER 2
Slightly dim
DIMMER 1
Even dimmer
DIMMER 0
Display off
o The display stays unlit even when the unit is on.
o Errors will be shown at ordinary brightness regardless of this
setting.
22
0dB

Automatic power saving function

This unit has an automatic power saving function.
o The automatic power saving function is on when the unit is
shipped new from the factory.
*AUTO POWER SAVE
> ON
OFF
The automatic power saving function is disabled.
ON
If no input signal is locked for about 20 minutes, the unit will
automatically enter standby mode.