Proxxon MicroMot 60/E Manual De Instrucciones página 15

The machine is reliably driven by a high torque
motor. Type 60/E is fitted with an electronic
speed regulator.
Length:
Weight:
Spindle collar:
Speed (60/E):
Voltage:
Power consumption:
Noise level:
Vibration:
Attention:
• Never press the lock button while the device
is operating.
• Depending on the collet size, bits and cutters
may have a shaft diameter of max. 3.2 mm.
• Insert the tools are far as possible when
clamping. Ensure that the shaft of the tool
does not stand out more than 30 mm from the
collet. Excessively protruding shafts can
bend easily and contribute to poor concen-
tricity.
• Do not in any case use bits and cutters with
an arbour length of more than 55 mm!
• When using collets, always make sure that
the collet chuck and the utilised tool have the
same shaft diameter! The arbour of the tool
must be seated firmly and securely in the col-
let!
• Do not work with damaged, bent or worn bits
and cutters! Make sure the tools are in per-
fect condition. Damaged or worn tools can
break and cause injuries!
• When storing the bits and cutters, make sure
they are reliably protected from damage!
• A correct and consistent speed achieves a
high grinding performance, not excessive
contact pressure!
• By tendency: Bits and cutters with smaller di-
ameters require higher speeds than those
with a larger diameter.
approx. 220 mm
approx. 230 g
Ø 20 mm
5000 to 20 000 rpm
12 to 18 V
approx. 40 W
< 70 dB (A)
≤ 2,5 m/ s
• Attention: You absolutely must observe the
permissible maximum speed of the bits and
cutters! The tool can break when the maxi-
mum permissible speed is exceeded. Flying
parts can cause
1. Press the lock button 1
2. Rotate the spindle with the sleeve nut 2
slightly while pressing the lock button simul-
taneously until it engages in the depression
on the spindle.
3. Loosen the sleeve nut
4. Remove the operational tool 3 if necessary
2
and insert a new one in the collet hole
5. Tighten the sleeve nut 2 while depressing
the lock button.
1. Press the lock button 1
2. Rotate the spindle with the sleeve nut 2
slightly while pressing the lock button simul-
taneously until it engages in the depression
on the spindle.
3. Unscrew the sleeve nut 2
4. Replace the collet 3
5. Screw on the sleeve nut while depressing
the lock button.
1. Push the non-reversible plug into the power
unit.
2. Switch the machine on
correct speed with the button .
Pressing hard does not achieve good results
when grinding. Use the correct speed and
maintain it.
3. Fig. 4 shows two typical methods for holding
MICROMOT 60. When working, ensure that
the tool is held firmly in order to guide the ro-
tating application tool in a controlled manner
without thereby blocking the ventillation slots.
(Fig. 1) and set the
Note:
- 15 -