Proxxon MicroMot 60/E Manual De Instrucciones página 16

4. If the unit overheats, switch it off and allow it
to cool for a few minutes.
The electronic speed regulation works only with
non-stabilized power units (e. g. all PROXXON
power units). If connected to a battery, the unit
will only run at max. speed.
Please do not dispose of the device in domestic
waste! The device contains valuable sub-
stances that can be recycled. If you have any
questions about this, please contact your local
waste management enterprise or other corre-
sponding municipal facilities.
Attention:
Every device is dirtied by dust when working.
Cleaning is therefore essential. To ensure a
long service life, however, the machine should
be cleaned with a soft cloth or brush after each
use.
Mild soap or other suitable cleaning agent may
be used in this context. Solvents or cleaning
agents containing alcohol (e.g. petrol, cleaning
alcohols, etc.) should be avoided, since these
can attack plastic casings.
The apertures required for cooling the motor
must always be kept free of dust and dirt.
For more detailed information on accessories,
please request our device catalogue from the
address specified on the last page in the war-
ranty information.
Proxxon bits and cutters have been designed
to work with our machines, which makes them
optimal for their use.
We will not assume any liability whatsoever for
the safe and proper function of our devices
when using third-party bits and cutters!
- 16 -
Please note: The mains power input may only
be replaced by our Proxxon Service Depart-
ment or a qualified specialist!
Name and address of the manufacturer:
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
Product designation:
Drilling and Milling Set with Micromot 60/E
Article No.: 28515
In sole responsibility, we declare that this
product conforms to the following directives
and normative documents:
EN 55014-1:2017
EN 55014-2:2015
EN 61000-3-2:2014
EN 61000-3-3:2013
EN 60745-1:2009/A11:2010
EN 60745-2-23:2013
Date: 03.02.2021
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Machine Safety Department
The CE document authorized agent is iden-
tical with the signatory.