Installation Steps - AVS Ventvisor Deflector Instrucciones De Instalación

Installation Steps

Clean the painted surface where the visor will
mount with an alcohol pad.
1
Align rear visor with previously cleaned surface.
Align front tape
flange with post
3
Remove the tape from the front flange of the
rear visor. The front visor will attach to the rear
visor at this location.
5
NOTE: Actual application may vary slightly from illustrations.
Peel back 2" of tape liner from back of rear visor at
rear
flange
2
Remove remaining tape liner. Apply pressure to secure
4
Remove 2" (5cm) of tape from each end of the
6
Page 2 of 3
each end of top flange.
top flange
front
flange
visor to vehicle.
front vent visor.