Royal Sovereign RBC-1100 Manual Del Proprietário página 9

machine will automatically begin to count them. When you remove the counted bills from the stacker and place new bills
into the hopper it will continue counting where it left off on the previous set of bills. To stop using ADD mode press the
ADD button again and the indicator light will shut off.
4. Test Run
Test the machine to make sure it is set to count your currency.
Prepare at least 5 bills to test the machine. Place the bills in the hopper and run the machine.
If the machine counts the bills and there are no errors, it is ready to use.
If:
1. The bills are deformed
2. The machine is considerably slow
3. Error message is lit frequently
The hopper tension is too tight. To loosen this tension, please turn the Hopper adjuster slightly towards the left.
Place the bills back into the hopper to test the machine again. If errors occur, adjust as necessary.
If:
1. The bills are flying out
2. The display shows a miscount
3. Error message it lit frequently
The hopper tension is too loose. To tighten this tension, please turn the Hopper adjuster slightly towards the right.
Place the bills back into the hopper to test the machine again. If errors occur, adjust as necessary.
When the machine is running without any errors, it is ready to use.
5. Insert bills into the hopper to begin counting.
All manuals and user guides at all-guides.com
9
RBC-1100