Operating For The First Time - General Information; How To Clean The Grinder - FAR GARY CI Manual De Instrucciones

English

OPERATING FOR THE FIRST TIME - GENERAL INFORMATION

Remove the attachment socket cover (2) and remove the screw (14).
1.
Place the worm cylinder (1) with the neck of the funnel turned upwards into the
2.
worm socket and turn the screw (14) in a clockwise direction until tightened.
Place the meat tray on the neck of the funnel such that the tray is placed above
3.
the arm.
Push the worm into the horizontal section of the cylinder until it locks into
4.
position. Consult the corresponding sections "Using the Grinder" and "Sausage
accessory".
Using the Grinder (see illustration A)
First place the grinding knife at the end of the blades and then the protection of
1.
your choice. Pay attention to the screen and to the recesses of the blades. Screw the
nut (13) until tight.
Place the pieces of meat on the tray (15) and into the neck of the funnel.
2.
Place a container under the end of the grinder.
3.
Ensure that the switch (7) is "Off ".
4.
Connect the appliance to a 220-240 V-, 50160 Hz safe circuit.
5.
GB-14
NOTE:
• Cut the meat into pieces of
around 2.5cm. Ensure that
the meat doesn't contain
any bones or tendons
Switch the meat grinder on using the dial (7).
6.
If necessary, push the meat using the stuffing tube (16). Do not push with your
7.
fingers.
A. Base motor unit
B. Locking screw
C.
Worm cylinder
D. Tray
E. Stuffing tube
F. Worm
G.
Grinder knife
H. Grinder plate (medium)
I. Grinder plate (fine)
J. Ring

HOW TO CLEAN THE GRINDER

Unplug the motor unit and remove the parts.
1.
Never immerse the power cable into water or any other liquid.
2.
Wash all parts except for the motor unit in warm soapy water, paying attention
3.
when handling sharp blades.
Rinse the parts in clean hot water and dry them thoroughly; NEVER clean the
4.
parts in a dishwasher. The knives and plates may rust if not dried and stored in the
appropriate manner. To protect these parts, coat them with cooking oil and wrap
them in grease proof paper.
Advice: to protect them from rust, vacuum wrap the parts using a food vacuum
sealer.
Wipe the motor casing using a damp cloth. Do not use aggressive or abrasive
5.
cleaning products.
Using the BLENDER
.
The appliance must be used in conjunction with the bowl and the bowl cover.
1.
WHEN USING THE APPLIANCE WITHOUT THE BLENDER, IT WILL
NOT WORK UNLESS THE BASE COVER HAS BEEN SCREWED INTO
THE FITTING SOCKET DESIGNED FOR THE BLENDER.
Before use: do not plug into the mains unless the blender jug and cover have been
2.
correctly fitted.
After use: unplug the appliance from the mains before removing the blender jug
3.
from the base.
Do not add ingredients whose temperature exceeds 80° into the BLENDER.
4.
In order to avoid it over-flowing, do not add more than 1.5L of liquid to the
5.
blender jug.
Never remove the cover while the blender is on.
6.
Note: Always remove the blender jug cover before fitting and removing it.
7.
Do not operate the blender for longer than 3 minutes.
8.
English
GB-15