Logitech QuickCam Manual Del Usuario página 4

3
Installing Your Camera
To use QuickCam
1. Install the software first! Insert the QuickCam Web software CD into
your computer's CD-ROM drive.
2. If the Setup screen does not display,
• Go to the Taskbar and click Start, then Run.
• Type D:\SETUP.EXE and press the Enter key, where D: is the drive
designation of your CD-ROM drive.
3. Follow the on-screen instructions.
4. Assemble the camera. After you reboot your system at the end of software
installation, Setup will prompt you to connect the camera cable to your computer:
• Remove the camera and its standard base and SmartClip
• Mount the camera on either the standard base or the SmartClip. The standard
base is used for traditional computer monitors. The SmartClip is used for flat
screen monitors (e.g., found on notebook computers) or tabletop use.
• Remove the protective cap from the end of the camera cable.
• Insert the camera cable into your computer's USB port.
• Continue to follow the on-screen prompts until you finish installing the camera.
2
Installing Your Camera
®
Web, you must run Windows
®
98 or later on your computer.
from the packaging.
™