STORING STATIONS INTO MEMORY continued
4. To select the desired memory page (00-99) use the
or hold down the STORE button and use the tuning knob.
5. While holding down the STORE button, press one of buttons F1-7,
storing the station into that memory. Note that a box appears
around the selected memory location.
6. Release the STORE button.
7. To store another station, tune to the station and repeat steps 4-6
above.
8. When finished storing stations, press the PAGE/TIME button to
exit MEMO mode.
SETTING ALARMS 1 THROUGH 4
The E5 has 4, independently programmable alarm timers (buttons
F1-4) to turn it on at a specified time. Additionally, each timer can be
programmed for a specific weekday, volume, playtime and memory
location.
To set an alarm:
1.
With the E5 turned off, perform a long press of one of the F1-4
buttons (about 3 seconds), causing the hour to flash.
2.
Use the tuning knob to set the hour; and press one of the F1-7
buttons to highlight the day of the week for turn on.
3.
Press the PAGE/TIME button.
4.
Use the tuning knob to set the minutes.
5.
Press the PAGE/TIME button.
6.
Use the tuning knob to set the wake-up volume.
7.
Press the PAGE/TIME button.
8.
Use the tuning knob to set the wake-up alarm's play minutes.
9.
Press the PAGE/TIME button.
10.
Use the tuning knob to set the page number or select no page
number by selecting ----.
11.
Press one of the F1-7 buttons to select the memory location on
the selected page (the square flashes).
12.
Press the PAGE/TIME button to finish the set-up.
E5
OWNER'S MANUAL
buttons
11