HEATER CONTROL
O FF
O FF
OPERATION :
1. Carefully remove your heater from the box and
bag.
2. Make sure that the heater is in the OFF (0)
position before plugging the heater into a outlet.
3. Place the heater on a firm, level surface.
4. The power light will light up when initially
plugging the heater into a outlet.
5. For heater operation, set the Thermostat knob to
the maximum setting (+).
6. Set Power knob to the desired heat setting. Low
heat (1000-1200W) is represented by the I and
High heat (1800W) by the II.
7. For fan-only operation, without any heat output,
turn Power knob to the fan setting represented by
.
8. The Power light will remain lit during operation.
STOP
FAN ONLY
LOW 1000-1200W
HIGH 1800W
17
9. To disconnect heater, turn Power knob to the OFF
(0) operation. Then remove the plug from the
outlet.
WARNING : METAL MESH IS HOT WHEN
HEATER IS IN OPERATION.
THERMOSTAT KNOB
1. Before setting the thermostat, allow heater to
operate and warm up the room. Set thermostat
knob to the maximum setting (+) to start the
heater.
2. When the desired temperature comfort level is
reached, lower the thermostat setting until the
heater stops operating. This is done by moving the
thermostat knob towards the minimum setting (-).
3. The heater will now automatically maintain the
pre-set temperature level by cycling the heater ON
and OFF (0).
18