Track Playback; Adjusting The Player Volume; Adjusting The Master Volume; Mixing Tracks - Silvercrest SDJ 100 A1 Manual De Instrucciones

SilverCrest SDJ 100 A1

Track playback

Press the II button [15] of the respective player to start playback of the loaded track. The II
button [15] lights up green during playback. To pause the track, press the II button [15] again.

Adjusting the player volume

You can adjust the player volume with the VOLUME control [9]. To this purpose use the VOLUME
control [9] of the respective player.
You can use this control, for example, to adjust the volume of two tracks to the
same level during mixing.

Adjusting the master volume

You can adjust the master volume with the MASTER VOLUME control [7]. The volume of both
players is then adjusted accordingly.

Mixing tracks

The CROSSFADER [11] permits crossfading of the tracks. If you move the CROSSFADER [11] to
the far left, only the track in player A is audible. If you only wish to listen to the track in player B, move
the CROSSFADER [11] to the far right. Set the CROSSFADER [11] to the centre position to listen
to both tracks (players A and B) at the same time.
If, for example, you want to crossfade from player A to player B, move the
CROSSFADER [11] from the left to the right.

Scratch and search functions

You can use the JOG WHEEL [4] to scratch the track or search for a position in the track. You can
also adjust the speed of a track. Press the SCRATCH/SEARCH button [10] to switch from SCRATCH
to SEARCH mode. If the SCRATCH/SEARCH button [10] lights up, SCRATCH mode is activated. If
the SCRATCH/SEARCH button [10] does not light up, SEARCH mode is activated.
28 - English