Uline Н-4291 Instrucciones De Ensamble página 3

Figure 1
2
Bottom End of Locker
Figure 2
4
5
First
Locker
Figure 3
PAGE 3 OF 12
1
2 Interior
Sides
1
2
ASSEMBLY
NOTE: Do not tighten bolts until unit is
completely assembled.
1. Place back (1) on a protected flat surface so that
the flanges face upward.
2. Bolt side (2) to back (1) so that side flange fits
around back (use 8 bolts and nuts - nuts to the
inside). Do not use bottom two holes; these will be
used for attaching legs in step 7. (See Figure 1)
3. Next, bolt top and bottom (5) to back and left side
panel (use 4 bolts and nuts each). Bolt shelf (4) to
left side panel. Next bolt an interior side and back
panel to the flange on the back of the first locker in
10 places.
4. Next attach a top and bottom to the first interior
side and back. Bolt shelf to the first interior side.
These will share bolts with the parts on either side of
them as shown in detail view.
5. Next attach remaining interior side and back to
flange of second back. Attach remaining top,
bottom and shelves to the interior side. Attach top
and bottom to the back. (See Figure 2)
6. Bolt remaining side (2) to the back so that side
flange fits around back. Attach side to top, bottom
and shelves. (See Figure 3)
0321 IH-4291