Descargar Imprimir esta página

Oce im2330 Manual De Instrucciones página 44

Publicidad

INSTALL
29
30
SET
33
Making HDD Partition
1. Turn the power ON while pressing [3] and
[CLEAR] simultaneously.
2. [3] → [START]
3. Check that "Initialize Completed" appears, and
then turn the power OFF.
Firmware Installation of HDD
1. Remove any preinstalled USB Enabler
(i.e., Scan, Print or Scan & Print).
1. Set the USB storage device (Fig. 1-1).
2. Turn the power ON while pressing [4] and [9]
simultaneously.
• After approx. 3 minutes, the selection menu
for update items is displayed.
SET
34
Confirmation of System Settings
[CAUTION]
1. Reset the value according to "FUNCTION LIST
If the cm4530110 optional Fax Kit is
FOR MAINTENANCE".
installed, perform the following
procedure from 1 to 4.
(1) Output "FUNCTION LIST FOR
Initialization of FAX
(2) Compare the output list and the list output in
1. Turn the power ON while pressing [1] and
[*] simultaneously. Make certain "Wait" is
not displayed before continuing.
2. [100] → [START] → [INITIALIZE]
3. [102] → [START] → [INITIALIZE]
4. Turn the power OFFby holding down
the ENERGY SAVER Key.
(3) Turn the power OFF.
INSTALL
31
3. Select the item to be updated with the digital keys.
• "*" is displayed in the selected item.
Select "HDD Update".
4. Press [START].
• Updating is started and the progress is displayed on
the screen.
5. Check that "Update Completed." appears, and then
turn the power OFF by using the font
ON/OFF switch.
6. Remove the USB storage device from the equipment.
7. Reinstall any USB Enabling devices that were installed
in step 1.
Fig. 1-1
2. According to the "FUNCTION LIST", reset the
value.
(1) Turn the power ON.
(2) Output the "FUNCTION LIST". (See step *4)
MAINTENANCE". (See step *4)
(3) Compare the output list and the list output
*4, re-set the value based on *4 list as for
different settings.
<Procedure for configuration>
Turn the power ON while pressing [1] and [3]
simultaneously.
Key in the "code" → [START] → Enter the
"value of *4 list" → [ENTER]
INSTALL
PLUG IN
32
Initialization of HDD
1. Turn the power ON while pressing [0] and [8]
simultaneously.
2. [690] → [START] → [2] → [ENTER]
• Never turn the power OFF while "SYSTEM MODE
WAIT" is displayed.
3. Check that "REBOOT THE MACHINE" appears, and
then turn the power OFF
by using the font ON/OFF switch.
Restoring User Data
Ask the customer to restore the backup data.
• For the items to be restored, see Chapter 3
of the Service Manual for cm4530290.
Confirm Installation
in *4, re-set the value based on *4 list as for
different settings.
1. User Function Key - Confirm that a Lock
is shown in the lower right-hand corner of
<Procedure for configuration>
the display
[USER FUNCTIONS] → [ADMIN] →
[PASSWORD] → "Admin Password"
(default: 123456) → [ENTER] →
Set the necessary items.
Rev. 08/07 6LE89814000
(3/3)
END
35

Publicidad

loading

Este manual también es adecuado para:

Im2830