Uline Н-6953 Instrucciones De Ensamblaje página 3

1
Figure 1
1
Figure 2
Figure 3
PAGE 3 OF 12
Top View
1 1 1
2 2 2 2
3
4
ASSEMBLY
ASSEMBLING MAIN PANELS
NOTE: Do not tighten bolts until unit is
completely assembled.
1. Place back panels (1) on a protected flat surface
so that the flanges face upward. (See Figure 1)
2. Bolt side panels (2) to back panels (1), making
2
sure side panels fit inside the flanges of the back
panels. The side panels should not go between two
back panel flanges. (See Figure 2) The ends of the
back and side panels with the two large holes are
at the bottom of the locker.
NOTE: Do not put nuts and bolts in the bottom
three holes in two outside corners. Those will
be used later to attach legs.
NOTE: Bolts will be shared between panels
that are next to each other.
3. Bolt top (3), bottom (3) and middle panels (3) to back
3
panels (1) and side panels (2). Only bolt through
middle hole when attaching to back panels.
(See Figure 3)
NOTE: Bolts will be shared between shelves
and panels that are next to each other.
4. Install one double ceiling hook (4) in each locker
opening. (See Figure 3)
0521 IH-6953