Uline Н-6953 Instrucciones De Ensamblaje página 4

8
Figure 4
Frame
Header
Figure 5
7
10
Figure 6
Figure 7
Push Pins
PAGE 4 OF 12
ASSEMBLY CONTINUED
6
Frame
12
11
9
6
5. Insert rear legs (8) into the corner between the
bottom and the side. Bolt the leg to the side and
back using six bolts and nuts per leg. (See Figure 4)
6. Place door and frame assemblies (5 and 6) over
the locker body. Make certain that body sides are
inside door frames. Attach top to frame header and
the bottom to frame sill. Finish by attaching side
panels to door frame. (See Figure 5)
5
Sill
7. Attach cover plate (11) to recessed handle (7) using
two bolts (10) and high-dome cap nuts (12).
(See Figure 6)
8. Attach number plates (9) using push pins.
(See Figure 7)
9. Check and tighten all bolts.
10. Stand unit upright and place in desired location.
SECURING UNITS
Anchor units to wall or floor. Unanchored units may fall
over if not secured. (Units standing back to back should
be bolted together.)
CAUTION: Care must be taken to assure
that lockers are set plumb and true before
anchoring.
1-800-295-5510
uline.com
0521 IH-6953