Threading The Optional Label Dispenser - Eltron 2642 Serie Manual Del Usuario

All manuals and user guides at all-guides.com
Threading The
Optional Label
Dispenser
Step
Step
Step
Step
980101-100 Rev.A
If your printer is equipped with the optional La-
bel Dispenser (PSAT or PSET) and you would
like the printer to automatically peel adhesive
labels from the backing, follow the steps below:
Perform steps 1-4 of the Loading Labels proce-
dure.
Peel the first two labels off the backing.
While pressing the FEED switch, push the label
backing into the peeler slot.
Open the print carriage and pull the label back-
ing out the bottom slot until it is tight across the
peeler bar. Close and lock the print carriage.
Activate the Label Taken Sensor by pressing in
on the top of the sensor.
Operation
47