Tool Holder, Attachments - Protool PDC 12-4 TEC Li Manual Original

LED red - flashes
General fault indication,
e.g. incomplete contact,
short circuit, defective bat-
tery pack, etc.
LED red - lit continuously
Battery temperature is out-
side the permitted range.
6.4 Light and battery capacity in-
dicator
The LED on the lamp [1-2] is both a
light and a battery capacity indicator
.
Press the LED light switch [1-1]:
1x ... LED, working area illumination
2x ... capacity indicator, indicates the
charging state of the battery pack (not
with NiCd and NiMH battery packs)
LED green – lit continu-
ously: charged > 60 %
LED green – flashing
slowly: charged 30 % –
60 %
LED green – flashing
quickly: charged 0 % –
30 %
LED yellow – lit contin-
uously: battery is empty
LED red – lit continu-
ously: battery tempera-
ture is outside the
permitted range.
LED red – flashing: indi-
cates a general fault, e.g.
incomplete contact, short
circuit, battery pack faulty,
etc.
7 Settings
WARNING
Risk of injury
Always switch off the machine before
adjusting settings!
7.1 Changing direction of rotation
[1-9]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise
rotation
14
All manuals and user guides at all-guides.com
7.2
You can change gear using the gear switch
[1-7].
7.3
Fastening
Select the correct torque setting:
Position 1 = low torque
Position 12 = high torque
An acoustic signal sounds when the pre-
set torque is reached and the machine
then switches off. You must release and
press the ON/OFF switch [1-4] again to
start the machine.
Drilling
Mark is aligned with drill symbol
imum torque.
7.4
Set the selector switch [1-6] to the ham-
mer symbol. Set the adjusting wheel [1-
8] to the drill symbol.
8
Risk of injury, electric shock
8.1
Quick change of tools with CENTROTEC
shaft
8.2
For clamping drill bits and bits with max.
shaft diameter of 13 mm.
8.3
Drilling and screwdriving at right angle to
machine (partly as an accessory).
Changing gear
Adjusting the torque[1-8]
Impact drilling
The machine was designed for impact
drilling into tiles, masonry and stone.

Tool holder, attachments

WARNING
Always disconnect the battery pack be-
fore any type of work on the machine!
Prior to initial use: apply multi-pur-
pose grease to the drill spindle and
gearbox neck.
CENTROTEC tool chuck [6]
Only clamp CENTROTEC tools in CEN-
TROTEC tool chucks.
Wear gloves when replacing!
Chuck [7]
Clamp tool centrally in the chuck.
Angle attachment [8]
= max-