Generator Features; Functional Description; Assembly - Snap-On 870828 Manual De Instrucciones

FUNCTIONAL DESCRIPTION

GENERATOR FEATURES:

1. Handle Kit
2. Fuel Tank
3. Fuel Tank Cap
4. Fuel Gauge
5. Choke Lever
6. Air Filter Housing
7. Fuel Valve
8. Recoil Starter
9. Engine On/Off Switch
10. Low Oil Sensor LED
11. Hour Meter
12. Circuit Protectors
13.120V AC, 20A, Duplex Outlet
14.120/240V AC, 30A, Locking Outlet
15. Grounding Terminal
16. Alternator Rear Cover
17. Oil Fill Cap
18. Rating Label
19. Leg Kit
20. Wheel Kit
21. Fuel Stabilizer
22. Engine Oil and Funnel
23. Tool Kit
15
This generator requires some assembly and will be ready for use after servicing with
manufacturer approved oil and fuel. If you have any problems with the assembly of
your generator, please call the generator helpline at 1-888-278-8092. If calling for
assistance, please have the model, revision, and serial number from the data tag
available.
1. Unpack Generator. Set carton on a rigid, flat surface. Remove all loose parts
and packing. Leave generator in carton.
Unit is heavy. Do not attempt to lift and remove
the generator unit from the carton.
2. Using a box cutter, open carton completely by cutting the four corners allowing
the sides to lay flat.
3. Carefully lift the generator from the engine side and place upright and proceed
with assembling the wheels, legs and handle using the provided tool kit and
following the procedure in the assembly illustration. Make sure all hardware are
tightened properly. For more detail, refer to "QUICK START GUIDE" document
supplied inside the generator shipping box.
4. After completion of the assembly, carefully
place the generator on its wheels and legs.
5. Lift the handle and move
the generator on a flat
surface to verify for proper
wheel and handle assembly.

ASSEMBLY

16