Important Safety Rules - Bellavita drive Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

If the device is not used for long periods of
time, the battery should be re-charged every
3 months in order to increase the longevity
of the device.
• Do not insert any conductive objects (e.g. need-
les, metal pins, etc.) into the jack socket of the
hand control.
• Always disconnect the mains plug from the
socket before cleaning the battery charger.
• Clean the battery charger with a dry cloth only.
• The Bellavita, battery charger and battery, are
built in a very robust way, but should not be
dropped. If you should find any visible and/or
audible signs of damage, do not use the bathlift
and notify your specialist dealer immediately.
We recommend entering the address of your
nearest representative on the last page of these
operating instructions.
• For further information, technical details and
addresses, please read the complete operating
instructions.
• In the event of a malfunction, please read our
"Troubleshooting" Chapter in the Appendix to
these operating instructions. Please observe
the information and instructions given there. For
your own safety, please do not use the bathlift
until any defect or malfunction is remedied.
For your own safety

Important safety rules

a) Always sit down in the middle of the lift with
your back against the backrest, with your legs
stretched slightly forward and place your free
hand either on the edge of the bath or on your
lap. Use the other hand to operate the hand
control to raise or lower the lift.
b) Whilst raising or lowering the lift, do not place
your hand between the bath edge and the
lift or underneath the seat as this may cause
injury.
c) Persons with severe or mental disabilities must
never be left unattended in the bath. Only take
a bath without any help if your ability allows
you to do so – otherwise, ask someone to
assist you.
d) Before using the bathlift a test run should be
carried out to check for the correct raising,
lowering and EMERGENCY STOP functions.
e) If a malfunction has occurred, do not operate
the bathlift and ask your specialist dealer to
remedy the problem.
f) Do not use any objects that could get stuck in
the mechanism (e.g. brushes, etc.) whilst using
the bathlift!
English · 5

Publicidad

Tabla de contenido
loading

Tabla de contenido