Troubleshooting; Specifications; Uvm-2600 / Uvm-3200 Models - Interlogix UVM-2600 Manual Del Usuario

Troubleshooting

Symptom Check
Picture is jittery Adjust
screen position and adjust
Clock value carefully until a
noise is no longer
displayed.
No picture Check if the power switch
and computer power switch
are in the On position
Check if the signal cable is
correctly connected to the
video card.
Check if the pins of D sub-
connector are not bent.
Check if the computer is in
the power- saving mode.
POWER LED is Check if power switch is in
not lit the On position.
Check if the power cord is
correctly connected.
Image is unstable Check if the signal cable is
suitable for the video card.
Image is not Adjust
centered, too Center
small or too large image.
Picture bounces Keep devices that may
or a wave pattern cause electrical interference
is present in the away from the monitor.
picture
See the FCC information at
the front cover of the
manual.

Specifications

UVM-2600 / UVM-3200 models

Items
Panel
EN 10
All manuals and user guides at all-guides.com
Clock to set the
Clock or H&V
to get the proper
Screen size
Pixel pitch
View angle (H/V)
Contrast ratio
Response time
Brightness
Recommended
resolution
Symptom Check
Picture is blurred Adjust
Brightness.
Low sound Adjust the volume on the
OSD menu.
Adjust the volume of the
sound card in the computer.
VIDEO screen Check if PICTURE mode
cannot be seen has been set.
Check if the video terminal
is properly connected.
No video Check if the video cable is
correctly connected to the
computer and set to
Functions
picture menu.
Poor color in the Adjust the
video values on the OSD Picture
menu.
Grainy picture in Adjust the
the video the OSD Picture menu.
UVM-2600 model
26 in. (66 cm)
0.4215 x 0.4215 mm
178°/178°
3000:1 (typ)
6.5 ms (G-to-G)
450 cd/m² (typ)
1366 x 768 @ 60 Hz
Contrast and
on the OSD
Color or Tint
Sharpness on
UVM-3200 model
32 in. (81.3 cm)
0.36375 x 0.36375 mm
178°/178°
5000:1 (typ)
6.5 ms (G-to-G)
450 cd/m² (typ)
1920 x 1080 @ 60 Hz
User Manual