Troubleshooting; Specifications; Uvm-2600 / Uvm-3200 Models - Interlogix UVM-2600 Manual De Usuario

Model

Specifications

VESA standard: 200 x
UVM-4200
200 mm and 400 x 200 mm
(7.87 x 7.87 in. and 15.75 x
7.87 in.)
Screw thread: M5 screw
Length: 10.0 mm

Troubleshooting

Symptom Check
Adjust
Picture is jittery
position and adjust Clock
value carefully until a noise is
no longer displayed.
No picture Check if the power switch and
computer power switch are in
the On position
Check if the signal cable is
correctly connected to the
video card.
Check if the pins of D sub-
connector are not bent.
Check if the computer is in the
power- saving mode.
POWER LED is Check if power switch is in the
not lit On position.
Check if the power cord is
correctly connected.
Image is Check if the signal cable is
Specifications

UVM-2600 / UVM-3200 models

Items
Panel Screen size
Pixel pitch
View angle (H/V)
Contrast ratio
Response time
Brightness
Recommended
resolution
EN 10
Clock to set the screen
UVM-2600 model
26 in. (66 cm)
0.4215 x 0.4215 mm
178°/178°
3000:1 (typ)
6.5 ms (G-to-G)
450 cd/m² (typ)
1366 x 768 @ 60 Hz
Symptom Check
unstable suitable for the video card.
Adjust
Image is not
to get the proper image.
centered, too
small or too
large
Picture bounces Keep devices that may cause
or a wave electrical interference away
pattern is from the monitor.
present in the
See the FCC information at
picture
the front cover of the manual.
Adjust
Picture is blurred
Brightness.
Low sound Adjust the volume on the OSD
menu.
Adjust the volume of the
sound card in the computer.
VIDEO screen Check if PICTURE mode has
cannot be seen been set.
Check if the video terminal is
properly connected.
Check if the video cable is
No video
correctly connected to the
computer and set to
Functions
picture menu.
Adjust the
Poor color in the
values on the OSD Picture
video
menu.
Adjust the
Grainy picture in
OSD Picture menu.
the video
UVM-3200 model
32 in. (81.3 cm)
0.36375 x 0.36375 mm
178°/178°
5000:1 (typ)
6.5 ms (G-to-G)
450 cd/m² (typ)
1920 x 1080 @ 60 Hz
Clock or H&V Center
Contrast and
on the OSD
Color or Tint
Sharpness on the
User Manual