Operating Instructions - Power smart DB5004 Manual De Instrucciones

OPERATING INSTRUCTIONS

Note: Before using this machine, make sure that the power source you will use complies with the
specifications detailed in this manual. Before inserting the plug into the socket, verify that the snow
thrower's auger and scraper are firmly attached with screws. Perform a test run to ensure that the
rotor turns freely.
SECURING THE EXTENSION CORD
1. For safe and efficient use of your snow thrower, use only a UL-rated extension cord
recommended for outdoor use. Refer to the Extension Cord Chart below.
WARNING
Electric shock may cause SEVERE INJURY or DEATH. Heed these warnings:
Do not allow any part of snow thrower to make contact with water while powered on. If the
appliance becomes wet while turned off, wipe dry before starting.
Use only a UL-rated extension cord for outdoor, all-weather use. Do not use an extension cord
more than 150 feet (46 meters) long.
Don't touch the appliance or its plug with wet hands or while standing in water. Wearing rubber
boots offers some protection.
EXTENTION CORD CHART
Cord length is: Up to 100 ft. (30 m)
Wire gauge is:
2. To prevent the extension cord from disconnecting
during use, tie the female end of the extension cord
into a loose knot on the cord lock (E) before connecting
to the male plug in the socket of the snow thrower.
3. Note that the snow thrower has a polarized male plug
(A), with one prong in the socket slightly longer and
wider than the other. The extension cord female end
should be likewise polarized, so that the extension
cord fits snugly into the socket.
All manuals and user guides at all-guides.com
100-150 ft.(30 m-46 m)
16
12
14
2
3
A
E
C