Level And Exhaust The Dryer - Whirlpool 8528095 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Level and Exhaust the Dryer

Dryer must be level to reduce noise and assure proper
performance.
Slide dryer onto cardboard or hardboard before moving across
floor to prevent floor damage.
1. Move dryer close to its permanent location. Leave enough
room to connect exhaust vent. Remove cardboard or
hardboard from under dryer.
2. Check levelness of dryer by placing a level on top of dryer,
first side to side, then front to back. If dryer is not level,
adjust dryer legs up or down.
3. If legs are not long enough to level dryer, order Extended
Dryer Feet Kit, Part No. 279810 (sold two legs per kit), from
your dealer.
4. Connect exhaust vent to exhaust outlet in dryer. The exhaust
vent must fit over the dryer exhaust outlet and inside the
exhaust hood vent.
Use 100 mm (4") vent clamps to seal all joints and to secure
exhaust vent to dryer exhaust outlet.
10.2 cm (4")
clamp
5. Move dryer into final position.
All manuals and user guides at all-guides.com
10.2 cm (4")
clamp
9

Publicidad

Tabla de contenido
loading

Tabla de contenido