Level And Exhaust The Dryer - Whirlpool 3HWED5205SQ0 Instrucciones De Instalación

7. Attach door hinge to door so large part of hinge slot is at
bottom of hinge.
8. Gently remove 4 hinge hole plugs (C) on left side of cabinet.
Insert plugs in hinge holes on right side of cabinet.
9. Insert screws in bottom holes on left side of cabinet. Tighten
screws halfway. Position door so large end of door hinge
slot is over screws. Slide door up so screws are in bottom
of slots. Tighten screws. Insert and tighten top screws in
hinges.
10. Remove door strike (D) from cabinet. Remove door strike
plug. Insert door strike in new hole and secure with screw.
Insert door strike plug in original door strike hole and secure
with screw.
11. Close door and check that door strike aligns with door catch
(E). If door does not close completely, slide door catch left
or right within slot until strike snaps into catch.
Dryer must be level to reduce noise and assure proper
performance.
Slide dryer onto cardboard or hardboard before moving across
floor to prevent floor damage.
1. Move dryer close to its permanent location. Leave enough
2. Check levelness of dryer by placing a level on top of dryer,
3. If legs are not long enough to level dryer, order Extended
4. Connect exhaust vent to exhaust outlet in dryer. The exhaust
5. Use 4" (10.2 cm) vent clamps to seal all joints and to secure
E
D
6. Move dryer into final position.

Level and Exhaust the Dryer

room to connect exhaust vent. Remove cardboard or
hardboard from under dryer.
first side to side, then front to back. If dryer is not level,
adjust dryer legs up or down.
Dryer Feet Kit, Part No. 279810 (sold two legs per kit), from
your dealer.
vent must fit over the dryer exhaust outlet and inside the
exhaust hood vent.
exhaust vent to dryer exhaust outlet.
4" (10.2 cm)
clamp
4" (10.2 cm)
clamp
9