MSW SHP9W.2 Guia Del Usuario página 3

können die Leitungen verstopfen und zu Schäden am
Gerät und seinen Komponenten führen..
gg) Das Gerät darf nicht an der Druckleitung getragen
oder aufgehängt werden.
hh) Wenn Sie ein Leck am Gerät oder an den Schläuchen
bemerken, trennen Sie sofort die Druckluftversorgung
und beheben Sie die Mängel..
ii) Der empfohlene Versorgungsdruck darf nicht
überschritten werden, da dies das Gerät beschädigen
kann.
jj) Das Gerät ist kein Spielzeug. Reinigung und Wartung
dürfen nicht von Kindern ohne Aufsicht durch eine
erwachsene Person durchgeführt werden..
kk) Es ist untersagt, in den Aufbau des Geräts einzugreifen,
um seine Parameter oder Konstruktion zu ändern.
ll) Geräte von Feuer – und Wärmequellen fernhalten.
mm) Überlasten Sie das Gerät nicht.
ACHTUNG! Obwohl das Gerät mit dem Gedanken
an die Sicherheit entworfen wurde, besitzt
es bestimmte Schutzmechanismen. Trotz der
Verwendung zusätzlicher Sicherheitselemente
besteht bei der Bedienung immer noch ein
Verletzungsrisiko. Es wird empfohlen, bei der
Nutzung Vorsicht und Vernunft walten zu lassen.
Das Produkt ist zur Demontage der Ventilfedern und zum
Austausch der Ventildichtungen am montierten oder
demontierten Zylinderkopf bestimmt.
Satz enthält:
• 1/4 '' Schnellanschlussadapter und 14- und 18-mm-
Zündkerzengewinde
• Luftschlauch für schwer zugängliche
Zündkerzenlöcher
• Aussperrung
• Magnetventilkeil
• Adapter für Druckluft - M24x20
• Adapter für Ventilfederscheibe
• Verbindungsstange
• Gebogene Zange
• Montagehülse - 110 mm
• Stoßbolzen
• Satz Schrauben mit Unterlegscheiben
• Stützen
• Montageflansche - 5/6/7/8/10/11 mm
• Befestigungsschrauben
4
U S E R M A N U A L
LEGEND
Read instructions before use.
The product must be recycled.
WARNING! or CAUTION! or REMEMBER!
Applicable to the given situation (general
warning sign).
Wear protective gloves.
Wear protective goggles.
WARNING! Toxic substances, danger of
poisoning!
ATTENTION! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury or even death.
The terms "device" or "product" are used in the warnings
and instructions to refer to VALVE SPRINGS SERVICE KIT.
a) Make sure the workplace is clean and well lit. A
messy or poorly lit workplace may lead to accidents.
Try to think ahead, observe what is going on and use
common sense when working with the device.
b) If you are unsure about whether the product is
operating correctly or if you find damage, please
contact the manufacturer's service centre.
c) Only the manufacturer's service centre may make
repairs to the product. Do not attempt to make
repairs yourself!
d) Children or unauthorised persons are forbidden to
enter a work station. (A distraction may result in loss
of control over the device).
e) Use the device in a well-ventilated space.
f) Only connect and disconnect the pressure line when
the air valve is closed.
g) Do not point the pressure line towards yourself or
toward other people or animals.
h) Do not cut off the supply of compressed air by
crushing or bending pressure hoses.
i) When starting the device, increase the air supply
to the device gradually in order to ensure that it is
functioning properly. If you notice any abnormal
operation of the device, disconnect it immediately
from
manufacturer's service point.
j) Please keep this manual available for future
reference. If this device is passed on to a third party,
the manual must be passed on with it.
k) Keep packaging elements and small assembly parts
in a place not available to children.
l) Keep the device away from children and animals.
m) If this device is used together with another
equipment, the remaining instructions for use shall
also be followed.
n) Do not use the device when tired, ill or under the
influence of alcohol, narcotics or medication which
can significantly impair the ability to operate the
device.
o) The device can be handled only by physically fit
persons who are capable of handling it, properly
trained, familiar with this manual and trained within
the scope of occupational health and safety.
Rev. 10.11.2020 Rev. 10.11.2020
p)
q)
r)
s)
t)
u)
v)
w)
x)
y)
z)
aa)
bb)
cc)
dd)
the compressed air and contact the
ee)
ff)
gg)
hh)
ii)
jj)
kk)
When working with the device, use common sense
and stay alert. Temporary loss of concentration while
using the device may lead to serious injuries.
Use personal protective equipment as required
for working with the device, specified in section 1
(Legend). The use of correct and approved personal
protective equipment reduces the risk of injury.
Use eye, ear and respiratory protection.
The device is not a toy. Children must be supervised
to ensure that they do not play with the device.
Do not overload the device. Use the appropriate
tools for the given task. A correctly-selected device
will perform the task for which it was designed better
and in a safer manner.
Make sure the pressure line is disconnected before
attempting any adjustments, accessory replacements
or doing any work on the device. Such a preventive
measure reduces the risk of an accident.
When not in use, store in a safe place, away from
children and people not familiar with the device who
have not read the user manual. The device may pose
a hazard in the hands of inexperienced users.
Keep the device in perfect technical condition. Before
each use check for general damage and especially
check for cracked parts or elements and for any other
conditions which may impact the safe operation of
the device. If damage is discovered, hand over the
device for repair before use.
Keep the device out of the reach of children.
Device repair or maintenance should be carried out
by qualified persons, only using original spare parts.
This will ensure safe use.
To ensure the operational integrity of the device, do
not remove factory-fitted guards and do not loosen
any screws.
When transporting and handling the device between
the warehouse and the destination, observe the
occupational health and safety principles for manual
transport operations which apply in the country
where the device will be used.
Clean the device regularly to prevent stubborn grime
from accumulating.
Only use air to supply the device, do not use any
other gases.
At locations where there is a high risk of mechanical
damage, use a reinforced hose for compressed air
connections.
Before each use ensure the nozzle is correctly
installed in the device and that the hose is correctly
attached and undamaged.
The air supplied to the device should be dry, clean
and free of contamination. Contamination can clog
the conduits and lead to damage to the device and
its components.
Do not carry or hang the device by the pressure line.
If you notice a leak from the device or hoses,
immediately disconnect the compressed air supply
and resolve the defects.
Do not exceed the recommended supply pressure as
this may damage the device.
The device is not a toy. Cleaning and maintenance
may not be carried out by children without
supervision by an adult person.
It is forbidden to interfere with the structure of
the device in order to change its parameters or
construction.
5