Urmet 1093 Manual De Usuario página 30

VERTICAL ADJUSTMENT
Loosen the ring on the bracket and the adjusting screws shown in the figure.
•
put the bracket in vertical position
•
point the camera at the vertical position
•
point the camera at the desired position
Once the adjustment has been performed, tighten the screws and the ring by locking it with the grub
screw and the suitable spanner (provided).
ADJUSTING SCREW
Important note:
Do not rotate excessively the camera, in order not to damage the cable inside the bracket.
1. Connect the video outputs to the selected devices (connectors: yellow=analog; silver=HD-SDI)
2. Connect the RS-485 cable (+/-) to a control keyboard (e. g. 1092/693) for camera control and
programming (all the parameters can be managed by a keyboard). Terminate the last device of
the line with a 120Ohm resistor. In case of long and/or underground cables, protect the device
with a dedicated filtering device (e.g. Urmet Ref, 1092/732).
3. Connect the power JACK (red connector) to the power supply unit and power-on the camera.
4. Unscrew the screw on the bottom of the camera to access to the adjustment screws and to the
OSD menu button.
30
All manuals and user guides at all-guides.com
UNSCREW
REGULATIONS
HD-SDI video signal, to be connected
to a 1093/800 SDI/HDMI converter or
to an SDI input of a DVR
Auxiliary analog video signal
FOR ACCESS TO
DS1093-083