Denver TC-32C Instrucciones De Operación página 38

- The unit is moved from a cold spot to a warm spot
- The heating system has just been turned on
- The unit is used in a very humid room
- The unit is cooled by an air conditioner
When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few
hours, then try to operate again.
Electric Power
1. Power sources - Use on batteries or external AC power supply, as specified in the Operating Instructions and
marked on the unit.
2. External AC power supply
- When disconnecting the AC power cord, pull it out by the AC power plug. Do not pull the cord itself.
- Never handle the AC power plug with wet hands, as this could result in fire or shock.
- Power cords should be firmly secured to avoid being bent, pinched, or walked upon. Pay particular attention to
the cord from the unit to the power socket.
- Avoid overloading AC power plugs and extension cords, beyond their capacity, as this could result in fire or
shock.
3. When not in use - Unplug the AC power supper from the AC outlet or remove all the batteries if the unit will not
be used for several months or more. When the cord is plugged in, a small amount of current continues to flow to
the unit, even when the power is turned off.
D POWER SUPPLY
IMPORTANT
Make sure that function is set to POWER OFF before connecting external AC power supply or inserting batteries.
CAUTION
Use only the supplied external AC power supply. Use with other cords may result in the risk of fire.
Using on batteries
Open the lid of the battery compartment on the rear and insert six (size C) batteries, not supplied, with the
marks correctly aligned. then close the lid.
To switch from external AC power supply to battery power supply, disconnect the external AC power supply.
The batteries need to be replaced when:
The radio sound is distorted during operation.
Notes on batteries
Do not mix different types of batteries or old batteries with new ones.
Never recharge the batteries, apply heat to them or take them apart.
Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to remove.
E CD OPERATION
1. Set function to CD.
2. OPEN the disc compartment and place a disc with the printed side up. The total number of tracks is
displayed.
3. Press PLAY/PAUSE to start play. The number of the track being played is displayed.
All manuals and user guides at all-guides.com
GB-3
and