Zanussi FE 827 GL FE 1027 G Manual De Uso página 14

7. Start the programme
Depress START/PAUSE
pilot light stops flashing. The door locked light
illuminates and only the pilot light
8. Altering an option or a programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the "Start/Pause"
button.
Changing a running programme is possible only by
resetting it.
Turn the programme selector dial to "O" and then to
the new programme position.
Start the new programme by depressing the
"Start/Pause" button. The washing water in the tub
will not emptied out .
9. Interrupting a programme
Depress the START/PAUSE button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the same button again to
restart the programme.
10. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
START/PAUSE button.
The door can be opened when the door locked light
has gone out.
If the door does not open (the door locked light
remains alight), this means that the water
temperature is above 55°C, that the water level is
above the bottom edge of the door or that the drum
is turning.
All manuals and user guides at all-guides.com
button, the corresponding
remains lit.
/
If you cannot open the door but you need to open it
you have to switch the machine off by turning the
programme selector dial to "O". After about 3
minutes the door can be opened (pay attention to
the water level and temperature!).
Select the programme again and depress
START/PAUSE to restart it.
11. At the end of the programme
The machine stops automatically. The Start/Pause
pilot light goes offand the End
on.
If the Rinse Hold option has been selected, the
door locked light is on to indicate that the water
must be emptied out before opening the door.
To do this turn the programme selector dial to "O"
and then to programme
The spin programme is performed at the maximum
speed. In order to avoid any creasing in synthetic,
delicate and wool items, the spin speed can be
reduced by means of the relevant selector dial.
The door can only be opened after the door
locked light has gone out.
Switch the machine off by turning the programme
selector dial to "O".
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
14
pilot light comes
(drain) or (spin).