broken.
CAUTIONS FOR USE
1.The more foods tuff put in or the more and the longer for once the door is opened, the more it needs
electric consumption, which even leads malfunction.
2.Better not to place the objects which are too heavy ,pointed or corrosion on table board.
3.Re-plugging in the power plug at the interval of over ten minutes.
4.Don't store bottled drink in the freezer, so as to prevent from being broken and damaging the
refrigerator.
5.Open the door as less as possible during power-cut.
6.When defrosting, never use any sharp or metallic objects to remove the frost on the surface of the
evaporator as it will damage the evaporator.
7.Don't touch foods and containers in the freezing compartment with your wet hands so as to prevent
from being frostbitten.
MAINTENANCE
1.While cleaning the refrigerator. pull out the electric power plug, rub carefully with a piece of cloth
soaked with natural cleanser then wipe with clean water. The abrasive cleaning power, alkali
cleansers, chemical cloth, thinner, alcohol, acid petroleum product and hot water are not suitable for
cleaning the refrigerator, they may damage the painting cover and plastics.
2.The door gasket is dirty and fogged easily, so clean it frequently.
3.If the refrigerator is out of use for a long time, please pull out the plug, clean and dry the freezing
compartment then close the door tightly.
THE FOLLOWING CASES ARE NOT MALFUNCTION
1.A flowing water sound:
Flowing water sound will be heard under normal operation.
2.Outside condensation:
Outside condensation is normal in high humidity condition. You may just wipe it up yourself.
3.It takes some times for the temperature of the freezer and refrigerator compartments to become cold
after the refrigerator starts to operate: If the temperature of the two compartments is higher while the
refrigerator is operating, it takes some times for the temperature of the two compartments to become
cold. If the environmental temperature is higher, it takes a long time to make the compartments to
become cold.
4. The surface of the compressor becomes hot:
The surface of the compressor may become hot under normal operation. Don't touch it with hands.
All manuals and user guides at all-guides.com
P-3