Troubleshooting - Thermador T24UW920RS Manual De Uso Y Cuidado

Troubleshooting

Be sure to check these items first:
Is there a power outage in the area?
Is the household fuse blown or the circuit breaker tripped?
Is the appliance properly connected to the electrical supply?
Many problems can be resolved without the need for a service call. See the following list as a reference of possible
solutions of simple problems.
Symptom
Appliance is not cooling.
The compressor is constantly
running or running too much.
Products and beverages in the unit are
too cold.
Page |12
Possible Cause
Appliance has been switched off.
Appliance opened frequently.
The ventilation openings have been
covered.
A large amount of product, or warm
product was placed into the appliance.
Excessively warm environment.
Leveling legs are not extended.
Door gasket is not sealing.
Temperature has been set too low.
Product placed too close to ventilation
holes.
Potential Remedy
Check display to make sure the unit is not
switched off. If display reads "OFF",
simultaneously press and hold LOCK and
WARMER to return to operating mode.
Do not open the appliance
unnecessarily.
Remove obstacles at the ventilation openings
located at the base of the unit and in the
refrigerator interiors.
The compressor will run more than
normal until the product cools. The
more that is added, the longer the motor will
run.
Avoid placing the unit in direct sunlight, or
near a heat source. If the appliance is in an
unusually warm environment, the
compressor will run more.
Extend the leg height to improve air
circulation. This will reduce the amount of
time the compressor needs to run.
Inspect the condition of the gasket. If
damaged, cold air can escape the cabinet
and cause the compressor to run more
than normal.
Increase the temperature. See "Setting the
temperature".
Rearrange the bottles, so that nothing
obstructs the interior ventilation holes.