Sauder 422406 Manual De Instrucciones página 14

Step 10
1
D16
K
Groove
Insert the DRAWER SIDES (D16 and D17) at an angle
å
into the slot at each end of the DRAWER FRONT (K).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Fasten the DRAWER BACK (D154) to the DRAWER SIDES (D16 and D17). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D959) inserts into the groove of the DRAWER BACK (D154).
å
Page 14
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D17
D154
D16
D959
VIEW THE T-LOCK BOX VIDEO
2
U n
s u
D959
D16
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D959) into the grooves in the
å
DRAWER SIDES (D16 and D17) and DRAWER FRONT (K).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D17
422406
With the palm of your
hand, tap the DRAWER
BOTTOM down into
the groove.
fi n
i s h
r f a
e d
c e
K
D17
30S
(4 used in this step)
www.sauder.com/services