Sinbo SSI 2865 ÜTÜ Manual De Instrucciones página 9

• The use of accessory attachments not recommended by the appliance manufacturer
may cause injuries.
•Do not use outdoors.
• Do not let cord hang over the edge of the table or counter, or touch hot surfaces.
• Do not place on or near a hot gas or electric burner, or in a heated oven.
• To disconnect. Remove plug from outlet. Let iron cool completely before putting away.
• Loop cord loosely around iron when storing.
• If an extension cord is absolutely necessary, a 10 ampere cord should be used.
• Do not use this appliance for anything else other than its intended use. This appliance
is for household use only.
IRON TEMPERATURE
• Always check first if a label with ironing instructions is attached to the article to be
ironed.
Follow these ironing instructions in all cases.
• If some kind of finish has been applied(gloss, wrinkle relief etc.).The textile can best
be ironed at a lower temperature.
• First sort out the fabrics according to ironing temperature: wool with wool, cotton with
cotton, etc.
• The iron heats up quicker than it cools down. Therefore start ironing the articles
requiring the lowest temperature such as those made of synthetic fabrics.
• Then progress to the higher temperatures .Finish by ironing cotton and linen.
• If the article is made of a mixture of different fibers. You must always select the lowest
ironing temperature of the composition of those fibers.(e.g.an article consisting of "60%
polyester and 40% cotton should be ironed on the temperature indicated for polyester.)
• If you do not know what kind of fabric the article has been made of find a spot which
will be invisible when wearing or using the article to try out the ironing temperature.(Always
start at a low temperature and increase to one which gives the required results.)
• Velvet and other textures which rapidly acquired should be ironed in one direction
only(with the nap)applying only light pressure. Always keep the iron moving.
• Iron the reverse side of synthetic materials and silk to prevent shining spots. To prevent
staining do not use the spray on silk or other delicate fabrics.
Setting the temperature
• Set the appropriate ironing temperature indicated in the ironing instructions of in the
fabric table by means of the temperature dial.
• Insert the mains plug into the wall socket. The pilot light will now come on.
• When the pilot light has gone out and has come on again you can start ironing.
• The pilot light will come on from time to time during ironing. This has no effect on the
ironing, so simply continue.
• If you set the temperature control to a lower setting after ironing at a high temperature,
do not recommence ironing before the pilot light comes on again.
- 8 -