Dip Switch Settings Overview; Function Setting - HTW BIBLOCK PLUS A60CGN8PLUS Manual De Usuario

Temperature curves for cooling mode
T4 - 10≤ T4＜15 15≤ T4＜22
1- T1S 16
2- T1S 17
3- T1S 18
4- T1S 19
5- T1S 20
6- T1S 21
7- T1S 22
8- T1S 23
T4 - 10≤ T4＜15 15≤ T4＜22
1- T1S 20
2- T1S 21
3- T1S 22
4- T1S 23
5- T1S 24
6- T1S 24
7- T1S 25
8- T1S 25
The automatic setting curve
The automatic setting curve is the ninth curve,the ninth curve can be set as following:
T1S (T1S2)
T1SETC1
T1SETC2
State:In the setting the wired controller, if T4C2<T4C1,then exchange their value; if T1SETC1<T1SETC2, then
exchange their value.

9.2 DIP switch settings overview

9.2.1 Function setting

DIP switch S1,S2 is located on the indoor unit main control board (see "8.3.1 main control board of indoor unit") and allows
configuration of additional heating source thermistor installation, the second inner backup heater installation, etc.
Switch off the power supply before opening the switch box service panel and making any changes to the DIP switch
settings.
22≤ T4＜30 30≤ T4
11 8 5
12 9 6
13 10 7
14 11 8
15 12 9
16 13 10
17 14 11
18 15 12
22≤ T4＜30 30≤ T4
18 17 16
19 18 17
20 19 17
21 19 18
21 20 18
22 20 19
22 21 19
23 21 20
T4C1 T4C2
WARNING
1 2 3 4 1
S1
43
T4
2 3 4 1 2
S2 S4
3 4