Husqvarna ROYAL 43 Manual Del Operador página 7

Preparation
1. Do not mow barefoot or in open sandals.
Always wear suitable clothing, gloves, and
stout shoes.
2. The use of ear protection is recommended.
3. Make sure the lawn is clear of sticks, stones,
bones, wire and debris; they could be thrown
by the blade.
4. Before using always visually inspect to see
that blades, blade bolts and cutter assembly
are not worn or damaged. Replace worn or
damaged blades together with their fixings in
sets to preserve balance.
5. Have faulty silencers replaced.
Use
Do not operate the engine in a confined
1.
space where exhaust fumes (carbon
monoxide) can collect.
2. Use the lawnmower only in daylight or good
artificial light.
3. Avoid operating your lawnmower in wet
grass, where feasible.
4. Take care in wet grass, you may lose your
footing.
5. On slopes, be extra careful of your footing
and wear non-slip footwear.
6. Mow across the face of slopes, never up and
down.
7. Exercise extreme caution when changing
direction on slopes.
8. Mowing on banks and slopes can be
dangerous. Do not mow on banks or steep
slopes.
9. Do not walk backwards when mowing, you
could trip. Walk never run.
10. Never cut grass by pulling the mower towards
you.
11. Release the Operator Presence control to
stop the engine before pushing the mower
across surfaces other than grass and when
transporting the lawnmower to and from the
area to be mowed.
12. Never operate the lawnmower with damaged
guards or without guards in place.
13 Do not overspeed the engine or alter
governor settings. Excessive speed is
dangerous and shortens lawnmower life.
14. Disengage all blade and drive clutches before
starting. (page 6)
15. Always start the lawnmower carefully with
feet well away from the blades.
16. Do not tilt lawnmower when starting the
engine
17. Do not put hands near the grass discharge
chute whilst engine is running.
All manuals and user guides at all-guides.com
SAFETY PRECAUTIONS
18. Never pick up or carry a lawnmower while the
19. Spark plug wire may be hot - handle with
20. Do not attempt any maintenance on your
21. Release the Operator Presence Control, to
-
22. Release the Operator Presence Control, to
-
-
-
-
-
23. Reduce the throttle setting during engine shut
Maintenance and storage
1.
2.
3.
4.
5.
6.
7.
8.
9.
engine is running
care.
lawnmower when the engine is hot.
stop the engine, and wait until the blade has
stopped:-
before leaving the mower unattended for any
period;
stop the engine, wait until the blade has
stopped, disconnect the spark plug lead and
wait until the engine has cooled:-
before refuelling
before clearing a blockage;
before checking, cleaning or working on the
appliance;
if you hit an object. Do not use your
lawnmower until you are sure that the entire
lawnmower is in a safe operating condition;
if the lawnmower starts to vibrate abnormally.
Check immediately. Excessive vibration can
cause injury.
down and, if the engine is provided with a
shut-off valve, turn the fuel off at the
conclusion of mowing.
Keep all nuts, bolts and screws tight to be
sure the lawnmower is in safe working
condition.
Check the grass collector frequently for wear
or deterioration.
Replace worn or damaged parts for safety.
Only use the replacement blade, blade bolt,
spacer and impeller specified for this product.
Never store the lawnmower with fuel in the
tank inside a building where fumes can reach
an open flame or spark.
Allow the engine to cool before storing in any
enclosure.
To reduce fire hazard, keep the engine,
silencer, battery compartment and fuel
storage area free of grass, leaves or
excessive grease.
If the fuel tank has to be drained, this should
be done outdoors.
Be careful during adjustment of the machine
to prevent entrapment of the fingers between
moving blades and fixed parts of the
machine.
2 - ENGLISH