Acoustic Signal - LaserLiner DigiLevel Compact Manual De Instrucciones

Switching on and measuring:
The DigiLevel can measure angles continuously to 360°.
• Switch the DigiLevel on using the on/off switch (1).
• The current operating temperature in °C is shown for a few seconds.
• The slope angle is shown in the display (6). If slopes are measured
overhead, the direction of display adjusts automatically.
• The current slope direction is also shown by the symbol (5).
Selection of unit of measurement:
• Button (2) allows the desired unit of measurement to be selected
(° degrees, %, IN/FT)
Changing the angle reference value:
• With button (3), it is possible to transfer angles elsewhere. To do so,
set the device to the desired slope and press button (3). The display will
then change to "0.0", and the desired reference angle is now set. The
slope can now be transferred to other objects.
When all the slopes have been transferred, make sure to deactivate
!
the new angle reference value. To do this, switch off the device by
pressing the on/off switch (1) for at least 3 secs. Only then will the
value be reset itself to the measuring surface (12).

Acoustic signal:

• The acoustic signal can be switched on or off with button (1).
• When the angle of slope stands at 0°, 45°, 90°, this is indicated
by an acoustic signal.
When working with a changed angle reference value, the
!
acoustic signal is activated on reaching the new reference
value (0°, 45°, 90° display).
Spirit level function:
• The alignment to the measuring surface (12) is shown by the vertical
and horizontal vials (9,10).
• Use the vials for optimum vertical and horizontal alignment, and the
electronic slope angle display for any desired angle of slope.
• With the aid of the magnets (11), the DigiLevel can be affixed to any
magnetic surface.
08
GB