König Electronic DL-DANCER250 Manual página 3

OPERATION:
Read "IMPORTANT INFORMATION BEFORE USE" first and verify all precautions are fulfilled before
operating.
Make sure the correct lamp is installed, read "SERVICE" on how to (re)place the lamp.
Although the DANCER250 cannot be dimmed, it may be switched on and off remotely using switch
packs or the full-on and full-off levels on dimmer packs. Disconnect the fixture from AC power when
not in use.
The DANCER250 has an advanced control panel. To set the desired function please read the following
instructions carefully.
Power
DMX address setting:
1. Press Menu to access address code setting menu Axxxx
2. Press UP or DOWN to set the DMX address code.
3. Press ENTER to save the update DMX address code.
Address code setting range A001-A512
Motor Speed and Sound Sensitivity setting:
1. Press Menu to access the menu StuP
2. Press ENTER to save the setting.
3. LCD display Mot1, press ENTER to access.
4. Press UP or DOWN to select motor speed, the range is 0-99.
5. Press ENTER to save the setting. Press Menu to exit.
6. In Mot1 interface, press UP or DOWN to select Mot2 and SEnS, the same setting as SenS is
sound sensitivity; 0 is closed, 99 max sound sensitivity.
StuP → Mot1
→ Mot2
→ SenS
Test program:
Press Menu to access the test program, select TESt and press ENTER to save the setting, the LCD
display flashes.
Press Menu to exit this scene.
Mode setting:
Press Menu to access the menu ModE and press ENTER button to save the setting.
Press UP or DOWN to select the mode of Auto or Sond or dMH.
Press ENTER to save the setting.
Press Menu to upgrade the menu.
All manuals and user guides at all-guides.com
Menu
Up
DMX
Control panel
0-99 Gobo motor speed
0-99 Gobo rotate motor speed
0-99 Sound sensitivity
3
Enter
Down
Sound